User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index

4-34 PRO/100 LAN+Modem PC Card User’s Guide
tion to activate serial port emulation. The COMx keyword can also be
stated on the command line with the modem-only driver
IMENABLE.COM.
Use the keywords COMIRQ and COMBASE to override the values set
with COM1, COM2, COM3, or COM4 in case of a conflict between LAN
and modem settings.
Sample NET.CFG File (ODI Driver) with COM Port Setting
LINK DRIVER M16BODI
INT 10
PORT 280
MEM D2000
COM3
Sample PROTOCOL.INI (NDIS Driver) with COM Port
Setting
[INTELNET]
DRIVERNAME=INTEL$
IRQ=10
IOADDRESS=0X320
MEM=0XD2000
MODE=IO
COM4
Sample Packet Driver Command Line with COM Port
Setting
M16BPD COM3 MEM=D8000
Sample IMENABLE.COM Command Line
IMENABLE COM3 MEM=D8000