User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index
Windows 3.x/MS-DOS Installation 4-27
SunSoft PC-NFS (version 3.5)
NDIS 2.0 Driver
1 Run the Intel Installation Program from the Installation Disk.
2 Choose SunSoft PC-NFS from the Select Network Operating
System screen.
3 Follow the prompts to complete the Intel installation.
4 Install PC-NFS for Ethernet according to instructions in the PC-
NFS documentation. Choose NDIS setup, and follow the
instructions to complete the setup. Note the prompt that tells you
that further manual modifications will have to be made.
5 Reboot the computer. You will see some error messages. Disregard
them and continue with these instructions.
6 Rename the file PROTOCOL.NFS in the C:\LANMAN directory
to PROTOCOL.INI. Use an text editor to edit the
PROTOCOL.INI file as follows:
Replace the items
[YOUR-MAC-MODULE]
DRIVERNAME = YOURMAC$
OPTION1 = VALUE1 ETC.
[NFS-NDIS]
DRIVERNAME = NFSLINK1
BINDINGS = YOUR-MAC-MODULE
with
[INTELNET]
DRIVERNAME = INTEL$
[NFS-NDIS]
DRIVERNAME = NFSLINK$
BINDINGS = INTELNET
7 Copy M16BNDIS.EXE from the C:\INTEL\M16B directory to
the C:\LANMAN directory.
8 Use a text editor to insert the following lines in your CONFIG.SYS
file: