User's Manual

4-18 PRO/100 LAN+Modem PC Card User’s Guide
10 Use a text editor to replace the line in your CONFIG.SYS file that
reads:
DEVICE=\XX.DOS
with the line
DEVICE=\M16BNDIS.EXE
11 Still in the CONFIG.SYS file, add the parameter O=N (where O is
a letter, not zero) to the line
DEVICE=\DXMT0MOD.SYS
as follows
DEVICE=\DXMT0MOD.SYS O=N
12 Copy M16BNDIS.EXE from the directory C:\INTEL\M16B to
the root directory of your hard disk or boot disk.
13 Change to the LANMAN directory on your hard disk or boot disk.
14 Use a text editor to modify the PROTOCOL.INI file in the C:\LSP
directory as follows:
 Under the ETHERAND section, change the line that reads
BINDINGS = TCMAC2
to:
BINDINGS = INTELNET
 Underneath that section insert a new section that reads:
[INTELNET]
DRIVERNAME = INTEL$
15 Use a text editor to edit the keyword settings in the
PROTOCOL.INI file in the C:\LSP directory to match the
keywords contained in the sample PROTOCOL.INI file located at
C:\INTEL\M16B as required (unless you are using Intel PRO/100
default settings).
16 Save the file and reboot the PC.
IBM PC LAN and IBM DOS LAN Requester
1 Install the IBM LAN Support Program according to the instructions
under the heading IBM Local Area Network Support Program,
which immediately precedes this one.