User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index
Windows NT Installation 3-9
Parameter Default Valid Values Registry Value
DIRECT ENABLE DISABLED DISABLED 0
ENABLED 1
EARLY TRANSMIT ENABLED DISABLED 0
ENABLED 1
FULL DUPLEX DISABLED DISABLED 0
ENABLED 1
FUNCTION(S) NETWORK NETWORK & MODEM 0
NETWORK ONLY 1
MODEM ONLY 2
INTERRUPT 5 3, 4, 5, 7, SAME
10, 11, 15
I/O PORT 0X320 0X200-0X3D0 SAME
I/O PORT 0X2E8 3F8,2F8,3E8,2E8 SAME
LINE SPEED AUTO DETECT AUTO DETECT 0
10MBPS 1
100MBPS 2
LINK INTEGRITY ENABLED DISABLED 0
ENABLED 1
MEMORY ADDRESS 0XD4000 0XA0000 - 0XFE000 SAME
MODE I/O I/O 0
MEMORY MAPPED 1
The network node address can be modified by manually editing the
registry and adding the parameter NetworkAddress with a hexadecimal
string value, such as 00A0C7112233. If the user does NOT specify a
NetworkAddress then the M16B.SYS driver uses the network node
address contained in the PRO/100 PC Card information structure.
There are parameters in the Windows NT registry which specify the
configuration of the PRO/100 PC Card hardware to the M16B.SYS
driver. Many of these parameters correspond directly to the user-
configurable parameters. These parameters are found in the registry at the
following location:
HKEY_LOCAL_MACHINE\SYSTEM\CURRENTCONTROLSET\SERVICES\M16B1\PARAMETERS\