User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index
3-6 PRO/100 LAN+Modem PC Card User’s Guide
9a For Windows NT 3.51 with Service Pack 5 or greater, specify:
\A:
9b For all other versions of Windows NT 3.51 specify:
A:\NT351.
Click OK.
10 Select Intel EtherExpress PRO/100 LAN+Modem PC Card and
click OK.
11 At the PRO/100 PC Card Setup screen, choose appropriate
settings. Click OK.
12 The Network Settings screen should show Intel EtherExpress
PRO/100 LAN+Modem PC Card under Installed Adapter Cards.
Click OK.
13 At the Network Settings Change screen, remove the Intel disk from
the disk drive and click Yes. The computer will be shutdown and
restarted.
14 To install the country identifier utility under any version of Win-
dows NT 3.51, run the Intel Installation Program from Intel Disk 1,
Installation Disk. Use the Program Manager File/Run sequence.
Type A:\SETUP in the Command Line box, and click OK. The
country identifier utility will be copied to your hard drive and an
icon installed in the Startup Group and Intel Mobile Program
Group. The program can be run by clicking on the appropriate icon,
or it will load automatically the next time the computer is restarted.