User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index
CHAPTER 6
Modem Reference
This chapter contains a comprehensive modem reference guide, including
result codes and all AT commands and S-Registers supported by the
PRO/100 LAN+Modem PC Card.
Result Codes
Long Short Description
OK 0 Command successfully executed
CONNECT 1 Connect
RING 2 Incoming ring signal detected
NO CARRIER 3 Carrier detect failed/carrier dropped
ERROR 4 Command is invalid
CONNECT 1200 5 Connection established at 1200bps
NO DIALTONE 6 No tone during interval set with S6
BUSY 7 Busy signal detected
NO ANSWER 8 Remote end never answered
CONNECT 2400 10 Connection established at 2400bps
CONNECT 4800 11 Connection established at 4800bps
CONNECT 9600 12 Connection established at 9600bps
CONNECT 14400 13 Connection established at 14400bps
CONNECT 19200 14 Connection established at 19200bps
CONNECT 57600 18 Connection established at 57600bps
CONNECT 1200/75 22 Connection at 1200 (Tx)/75 (Rx) bps