User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index

Utilities and Applications 5-11
2 Click Preferences.
3 In the Connection window under Connection Type check all
settings for accuracy.
a Winsock: (Default WINSOCK).
b Connect using:
c Phone #:
d Port:
e Port speed:
f Dial type:
Modify any of the above settings are not valid.
4 To modify the modem type, click Define Modem, highlight Intel as
manufacturer and the EtherExpress PRO/100 LAN+Modem PC
Card model.
Note
The default initialization string should suffice. To modify your
initialization string, click Define Modem and enter the new
initialization string in the Initialization section.
5 Click OK to save configuration and exit.
LapLink version 6.0
To set up the Intel modem or modify the present configuration:
1 In the Control Panel, click the Modem icon to access the Port Setup
window.
2 In the Port Setup Screen.
a Click the communications port that corresponds to the one
assigned to the modem.
b Select Modem under Type.