System Handbook
Table Of Contents
Appendix (Additional assessments outside the scope of SCS 0108)
Antenna Parameters with Head TSL
Impedance, transformed to feed point
so.8
n - 3.8
jn
Return Loss - 28.2 dB
General Antenna Parameters and Design
Electrical Delay (one direction) 1.390 ns
After long term use with 1
OOW
radiated power, only a slight warming of the dipole near the feedpoint can be measured.
The dipole is made of standard semirigid coaxial cable. The center conductor of the feeding line is directly connected to the
second arm of the dipole. The antenna is therefore short-circuited for DC-signals. On some of the dipoles, small end caps
are added to the dipole arms
in
order to improve matching when loaded according to the position as explained
in
the
"Measurement Conditions" paragraph. The SAR data are not affected by this change. The overall dipole length is still
according to the Standard.
No excessive force must be applied to the dipole arms, because they might bend or the soldered connections near the
feedpoint may be damaged.
Additional EUT Data
I Manufactured by
SPEAG
Certificate
No:
D835V2-4d167 _Nov19
Page 4
of
7