Guide

Mechanical Drawings
96 Intel® Xeon® Processor E7 2800/4800/8800 v2 Product Family
Thermal/ Mechanical Specifications and Design Guide
Figure G-5. ILM Volumetric Keep-out Drawing - G52827 Rev A
13
4
5678
B C D
A
123
4
5678
B C D
A
2200 MISSION COLLEGE BLVD. P.O. BOX 58119 SANTA CLARA, CA 95052-8119
R
3.282 [83.36]
3.270 [83.06]
110.0°
50.0°
110.0°
2.650 [67.31]
3.407 [86.53]
3.150 [80]
4.232 [107.5]
3.150 [80]
3.622 [92]
.099 [2.5]
G52827 1 A
DWG. NO SHT. REV
SHEET 1 OF 1
DO NOT SCALE DRAWING
SCALE: 2:1
AG52827D
REV
DRAWING NUMBER
SIZE
KOV,SKT-R1 ILM
TITLE
PTMI
DEPARTMENT
SEE NOTESSEE NOTES
FINISHMATERIAL -- DATEAPPROVED BY -- -- DATECHECKED BY 12-1-11T. BOYD DATEDRAWN BY 12-1-11T. BOYD DATEDESIGNED BY
UNLESS OTHERWISE SPECIFIED INTERPRET DIMENSIONS AND TOLERANCES IN ACCORDANCE WITH ASME Y14.5M-1994 DIMENSIONS ARE IN INCHES (MM) TOLERANCES:
THIRD ANGLE PROJECTION
REVISION HISTORY
ZONE REV DESCRIPTION DATE APPR
A INITIAL RELEASE WITH IPN ASSIGNED 12-1-11 TAB
THIS DRAWING CONTAINS INTEL CORPORATION CONFIDENTIAL INFORMATION. IT IS DISCLOSED IN CONFIDENCE AND ITS CONTENTS MAY NOT BE DISCLOSED, REPRODUCED, DISPLAYED OR MODIFIED, WITHOUT THE PRIOR WRITTEN CONSENT OF INTEL CORPORATION.
NOTES: 1. THIS DRAWING DEFINES THE ENABLED RETENTION MECHANISM SWEPT VOLUME. IT IS INTENDED FOR USE BY BOARD AND SYSTEM DESIGNERS TO ENSURE PROPER FUNCTION AND ACCESS TO THE PROCESSORS. 2. THIS DRAWING TO BE USED IN CORELATION WITH SUPPLIED 3D DATA BASE FILE. ALL DIMENSIONS AND TOLERANCES ON THIS DRAWING TAKE PRECEDENCE OVER SUPPLIED FILE. 3. DIMENSIONS STATED IN INCHES (MILLIMETERS) AND DEFINE ZONES, THEY HAVE NO TOLERANCES ASSOCIATED WITH THEM. UNLESS OTHERWISE NOTED ALL VIEW DIMENSION ARE NOMINAL. ALL HEIGHT RESTRICTIONS ARE MAXIMUMS. NEITHER ARE DRIVEN BY IMPLIED TOLERANCES.
BACKSIDE KOV
TOP SIDE SWEEP ZONES
VOLUMETRIC SWEEPS FOR LOADPLATE AND LEVERS DURING OPENING AND CLOSING
LOAD PLATE SWEEP
HINGE LEVER SWEEP
TONGUE LEVER SWEEP