Data Sheet

Electrical/Mechanical Specification—Ethernet Controller I210
801
11.6.6 Switching Voltage Regulator (SVR) Capacitor Electrical
Specifications
The following table lists the electrical performance of the 0.9V/1.5V SVR.
11.7 Package
The I210 is assembled in one, single package type: 9 mm x 9 mm 64-pin QFN package.
11.7.1 Mechanical Specification for the 9 x 9 QFN Package
11.7.2 9 x 9 QFN Package Schematics
Refer to Figure 2-2.
11.8 Flash Devices
While Intel does not make recommendations regarding these devices, the following devices might
match to be used successfully. Minimum Flash size required is 8 Mb or 16 Mb, depending if an
Expansion/Option ROM module is needed.
Frequency Tolerance f/f
o
±50 [ppm] -20 to +70 [°C]
Operating Temperature T
opr
0 to +70 [°C]
-40 to +85 [°C]
Commercial grade
Industrial grade
Maximum jitter 12KHz-20 MHz RMS
1
1.5 [ps]
1. At the XTAL1 input.
Parameter Min Typ Max Unit Comments
Regulator input voltage 2.97 3.3 3.465 V
Regulator output voltages
0.9
1.5
V
Output Voltage Accuracy 5 % Not including line and load regulation errors.
Load Current 0 175 mA 175mA (max) for each 0.9V and 1.5V rail.
Startup Time 4 5 6 ms
Load Capacitor 20 µF Ceramic bulk capacitors.
Flying Capacitor 39 nF Located close to package related pins.
Table 11-18. I210 9 x 9 Package Mechanical Specifications
Body Size Pin Count Pin Pitch Ball Matrix Center Matrix Substrate
9 x 9 64 0.5 mm N/A, peripheral N/A, exposed pad
N/A, led frame-based
package
Table 11-17. Specification for External Clock Oscillator (Continued)