Data Sheet

System Manageability—Ethernet Controller I210
779
Table 10-92. Set NS Proxy Table Entry Command
Firmware returns the following status for this command:
Byte Name Bit Value Description
0 Command 7:0 0x78 Set NS proxy command
1 Buffer length 7:0 0x4B
2 Reserved 7:0 0x0 Must be zeroed by host
3 Checksum 7:0 Checksum signature
4 Port Number 7:0 Port Number
Indicates the port number that the command is targeted
at.
Note: Port number is always set to 0x0 in the I210
5 Sub command 7:0 0x3 Set proxy capabilities
6 NS proxy version 1 7:0 0x2 NS version 1 entry
7 Table index 7:0 Index
Table index
Each Set proxy command is held in a separate Table
index. Field defines Table Index for current command.
Notes:
1. Table Index values begin at 1.
2. Up to two NS proxy table entries are supported and
only Table index values of 1 and 2 are valid.
3. To change contents of a table entry the relevant
Table index should be invalidated (Write command
to the Table index with Active field = 0x0) before
writing new content.
8 Active 7:0 0x1 or 0x0
Set to 0x1 to activate table index
Set to 0x0 to invalidate it
If set to 0, values of all following fields are ignored
14:9 MAC Address 7:0 MAC Address
30:15 Local IPv6 Address 1 7:0
Local IPv6 Address 1.
This address is used by firmware for NS proxying.
46:31 Local IPv6 Address 2 7:0
Local IPv6 Address 2
If there is only one local address value placed here is
0x0.
When not 0x0, this address is used by firmware for NS
proxying.
62:47 Remote IPv6 Address 7:0
Remote IPv6 Address
A value of 0x0 indicates any address.
78:63 Solicited IPv6 Address 7:0
Solicited IPv6 Address.
This address is used by firmware for MLD proxying.