Data Sheet

Ethernet Controller I210 —System Manageability
776
Table 10-89. Set Firmware Proxying Configuration Response
10.8.2.4.2.3 Set ARP Proxy Table Entry
Note: To set an entry Software driver will post command with Active field set to 0x1. To disable an
entry the driver must post this entry with the Active field set to 0x0. Driver must initially
disable all unused entries.
Byte Name Bit Value Description
0 Command 7:0 0xEB Get Firmware Proxying Capabilities
1 Buffer length 7:0 0x6
2 Return Status 7:0 0x1
0x0 - Undefined Error
0x1 - Status OK
0x2 - Unsupported command
0x3 - Checksum Error
0x4 - Buffer Length Error
0x5 to 0xFF - Error
3 Checksum 7:0 Checksum signature
4 Port Number 7:0 Port Number Indicates the port number that the status is from.
5No Match 7:00x1
No Match command
Defines how Firmware handles unsupported proxying
packets.
6 No Match data 7:0 0x0 or 0x1
No Match Data
0x0 - Discard unsupported proxying packets
0x1 - Issue Wake on reception of unsupported packets.
Note: 0x0 is the default value if no configuration
command is issued.
7 Reserved 7:0 0x0 Reserved
8 Reserved 7:0 0x0 Reserved
9 Enable MLD 7:0 0x0, 0x1 or 0x2
Copied from the Set Firmware Proxying Configuration
Command