Data Sheet

System Manageability—Ethernet Controller I210
775
Table 10-88. Set Firmware Proxying Configuration Command
Firmware returns the following Response for this command:
Byte Name Bit Value Description
0 Command 7:0 0xEB Set Firmware Proxying Configuration
1 Buffer length 7:0 0x6
2 Reserved 7:0 0x0 Must be zeroed by host
3 Checksum 7:0 Checksum signature
4 Port Number 7:0 Port Number
Indicates the port number that the command is targeted
at.
Note: Port number is always set to 0x0 in the I210
5 No Match 7:0 0x1
No Match command
Defines how Firmware handles unsupported proxying
packets.
6 No Match data 7:0 0x0 or 0x1
No Match data
0x0 - Discard unsupported proxying packets
0x1 - Issue Wake on reception of unsupported packets.
Note: 0x0 is the default value if no configuration
command is issued.
7 Reserved 7:0 0x0 Reserved
8 Reserved 7:0 0x0 Reserved
9 Enable MLD 7:0 0x0, 0x1 or 0x2
0x0: Do not enable MLD
0x1: Enable MLD version 1
0x2: Enable MLD version 2
0x3 - x0FF: Reserved