Data Sheet

System Manageability—Ethernet Controller I210
743
address can be added to a binding only if previously enabled through a Set MAC Address NC-SI
command
• Enabled VLAN: The VLAN IDs participating in this binding. The numbering of the VLAN IDs. A VLAN
tag can be added to a binding only if previously enabled through a Set VLAN Filter NC-SI command.
• Enabled IP addresses: The IP addresses participating in this binding. The numbering of the IP
addresses is simillar to the one used in the Get Shared IP Parameters Response
(Section 10.6.3.14.9). An IP address can be added to a binding only if previously enabled through a
Set IP Address Intel OEM command.
• Enabled Ports: The ports participating in this binding. A Port can be added to a binding only if
previously enabled through a Set Port Intel OEM command.
10.6.3.14.10.1Set Binding Address Response
The Network Controller shall, in the absence of a checksum error or identifier mismatch, always accept
the Set Binding command and send a response, using the format specified in Table 10-74.
10.6.3.14.11Get Binding Command (Intel Command 0x25, Index = 0xA)
A Management Controller uses the Get Binding command to determine the current programming of one
of the bindings in a Network Controller. The format of a Get Binding command packet is specified in
Table 10-75.
• Binding Index: Indicates which binding is requested by the command.The value should be smaller
than the number of supported bindings as reported in the Get Shared IP Capabilities Response in
the Number of Bindings field.
Table 10-74. Set Binding Response Packet Format
Bits
Bytes 31..24 23..16 15..08 07..00
00..15 NC-SI Header
16..19 Response Code Reason Code
20..23 Manufacturer ID (Intel 0x157)
24..27 0x25 0x9 Reserved
28..31 Checksum
Table 10-75. Get Binding Command Packet Format
Bits
Bytes 31..24 23..16 15..08 07..00
00..15 NC-SI Header
16..19 Manufacturer ID (Intel 0x157)
20..23 0x25 0xA Binding Number Reserved
24..27 Checksum