Data Sheet

Ethernet Controller I210 —System Manageability
740
10.6.3.14.9 Get Shared IP Parameters Command (Intel Command 0x25, Index = 0x8)
The Get Shared IP parameters command can be used by the Management Controller to request that the
channel send the Management Controller a copy of part of the currently stored parameter settings that
have been put into effect by the Management Controller related to shared IP filtering. The format of a
Get Shared IP Capabilities command packet is specified in Table 10-68.
10.6.3.14.9.1Get Shared IP Parameters Response
The Network Controller shall, in the absence of a checksum error or identifier mismatch, always accept
the Get Shared IP Parameters command and send a response, using the format specified in Table 10-
69. Currently no command-specific reason codes are identified for this response.
• Number of IP addresses - The number of supported IP filters including all the types of IP addresses
(IPv4 only, IPv6 only and mixed).
• IP address flags: The enable/disable state for each supported IP address. See Table 10-70.
Table 10-68. Get Shared IP Parameters Command Packet Format
Bits
Bytes 31..24 23..16 15..08 07..00
00..15 NC-SI Header
16..19 Manufacturer ID (Intel 0x157)
20..23 0x25 0x8 Reserved
24..27 Checksum
Table 10-69. Get Shared IP Parameters Response Packet Format
Bits
Bytes 31..24 23..16 15..08 07..00
00..15 NC-SI Header
16..19 Response Code Reason Code
20..23 Manufacturer ID (Intel 0x157)
24..27 0x25 0x8 Reserved
28..31 Number of IP Addresses IP addresses Flags
32..35 Number of ports Ports Flags
36..39 Unicast Infrastructure Filter Settings
40..43 Broadcast Filtering Settings
44..47 Multicast Filtering Settings
48..51 Checksum
Table 10-70. IP address flags Field
Bit Position Field Description Value Description
0 IP address 1 status
0b = Default or unsupported or disabled
1b = Enabled
1
IP address 2 status or
Reserved
0b = Default or unsupported or disabled
1b = Enabled