Data Sheet

System Manageability—Ethernet Controller I210
735
10.6.3.14.5.1Enable Unicast Infrastructure Filter Response
The Network Controller shall, in the absence of a checksum error or identifier mismatch, always accept
the Enable Unicast Infrastructure Filter command and send a response, using the format specified in
Table 10-58. Currently no command-specific reason codes are identified for this response.
10.6.3.14.6 Get Shared IP Capabilities Command (Intel Command 0x25, Index = 0x5)
8
RMCP Primary port - TCP
packets received from wire
0x1 = Forward this packet type to the Management Controller only
0x0 = Forward this packet type to the Host
For the purposes of this filter, a RMCP Primary port TCP packet is defined to be any
packet that meets all of the following requirements:
•The Ethernet Destination Address field contains the MAC address assigned to
the management controller.
•The Ethernet Type field contains 0x86DD (IPv6) 0r 0x0800 (IPv4).
•The IP Destination Address field contains the one of the IP address assigned to
the management controller.
•The IP Protocol field contains 6 (TCP).
•The TCP Destination Port field contains 623 (Aux Bus Shunt (Primary RMCP
Port)).
9
RMCP Secondary port - UDP
packets received from wire
0x1 = Forward this packet type to the Management Controller only
0x0 = Forward this packet type to the Host
For the purposes of this filter, a RMCP Secondary port TCP packet is defined to be
any packet that meets all of the following requirements:
•The Ethernet Destination Address field contains the MAC address assigned to
the management controller.
•The Ethernet Type field contains 0x86DD (IPv6) 0r 0x0800 (IPv4).
•The IP Destination Address field contains the one of the IP address assigned to
the management controller.
•The IP Protocol field contains 17 (UDP).
•The UDP Destination Port field contains 664 (Secure Aux Bus (Secondary RMCP
Port)).
10
RMCP Secondary port - TCP
packets received from wire
0x1 = Forward this packet type to the Management Controller only
0x0 = Forward this packet type to the Host
For the purposes of this filter, a RMCP Secondary port TCP packet is defined to be
any packet that meets all of the following requirements:
•The Ethernet Destination Address field contains the MAC address assigned to
the management controller.
•The Ethernet Type field contains 0x86DD (IPv6) 0r 0x0800 (IPv4).
•The IP Destination Address field contains the one of the IP address assigned to
the management controller.
•The IP Protocol field contains 6 (TCP).
•The TCP Destination Port field contains 664 (Secure Aux Bus (Secondary RMCP
Port)).
11..31 Reserved None
Table 10-58. Enable Unicast Infrastructure Filter Response Packet Format
Bits
00..15 NC-SI Header
16..19 Response Code Reason Code
20..23 Manufacturer ID (Intel 0x157)
24..27 0x25 0x4 Reserved
28..29 Checksum
Table 10-57. Unicast Infrastructure Packet Filter Settings Field