Data Sheet

System Manageability—Ethernet Controller I210
731
10.6.3.14.3.1Set Port Response
The Network Controller shall, in the absence of a checksum error or identifier mismatch, always accept
the Set Port command and send a response, using the format specified in Table 10-51.
10.6.3.14.4 Get Port Command (Intel Command 0x25, Index = 0x3)
A Management Controller uses the Get Port command to determine the TCP or UDP port programmed in
one of the port filters in a Network Controller. The format of a Get Port command packet is specified in
Table 10-52.
Table 10-53 describes the fields in the Get Port command.
10.6.3.14.4.1Get Port Response
The Network Controller shall, in the absence of a checksum error or identifier mismatch, always accept
the Get Port command and send a response, using the format specified in Table 10-54.
Table 10-51. Set Port Response Packet Format
Bits
Bytes 31..24 23..16 15..08 07..00
12..15 NC-SI Header
16..19 Response Code Reason Code
20..23 Manufacturer ID (Intel 0x157)
24..27 0x25 0x2 Reserved
28..31 Checksum
Table 10-52.Get Port Command Packet Format
Bits
Bytes 31..24 23..16 15..08 07..00
00..15 NC-SI Header
16..19 Manufacturer ID (Intel 0x157)
20..23 0x25 0x3 Reserved
24..27 Reserved Port Index Reserved
28..31 Checksum
Table 10-53. Get Port Command Field Descriptions
Field Field Description Value Description
Port Index
Indicates which port filter is
requested by the command.
1 to n, where n is the number of port filters supported by the Network
Controller.
Table 10-54. Get Port Response Packet Format
Bits
Bytes 31..24 23..16 15..08 07..00
00..15 NC-SI Header