Data Sheet

System Manageability—Ethernet Controller I210
719
Note: Packets that might have been blocked can still pass due to other decision filters.
In order to disable broadcast packet reduction, the MC should set all reduction filters to 0b. Following
such a setting, the NC must forward, to the MC, all packets that have passed the broadcast filters as
specified in the DMTF NC-SI.
The command shall overwrite any previously stored value.
10.6.3.7.11 Set Broadcast Extended Packet Reduction Response (Intel Command 0x04,
Reduction Filter Index 0x12)
10.6.3.8 Get Intel Packet Reduction Filters Formats
Note: The non extended commands (Section 10.6.3.8.3 to Section 10.6.3.8.6) are not supported
anymore. Use the extended commands (Section 10.6.3.8.6 to Section 10.6.3.8.11) instead.
10.6.3.8.1 Get Intel Packet Reduction Filters Command (Intel Command 0x05)
This command is not supported anymore. Use the Get Unicast Extended Packet Reduction Command
(Intel Command 0x05, Reduction Filter Index 0x10) instead (Section 10.6.3.8.6).
10.6.3.8.2 Get Intel Packet Reduction Filters Response (Intel Command 0x05)
Bits
Bytes 31:24 23:16 15:08 07:00
00..15 NC-SI Header
16..19 Response Code Reason Code
20..23 Manufacturer ID (Intel 0x157)
24..25 0x04 0x12
Bits
Bytes 31:24 23:16 15:08 07:00
00...15 NC-SI Header
16...19 Manufacturer ID (Intel 0x157)
20...21 0x05 Reduction Filter Index
Bits
Bytes 31:24 23:16 15:08 07:00
00...15 NC-SI Header
16...19 Response Code Reason Code
20...23 Manufacturer ID (Intel 0x157)
24... 0x05 Reduction Filter Index Return Data