Data Sheet

Ethernet Controller I210 —System Manageability
702
10.6.3.5.7 Set Intel Filters — Flex Filter Data Command (Intel Command 0x02, Filter
Parameter 0x11)
The Filter Data Group parameter defines which bytes of the Flex filter are set by this command:
Note: Using this command to configure the filters data must be done after the flex filter mask
command is issued and the mask is set.
10.6.3.5.8 Set Intel Filters — Flex Filter Data Response (Intel Command 0x02, Filter
Parameter 0x11)
Note: If Filter Data Length is larger than specified in Table 10-36 an Out of Range Reason code is
returned.
10.6.3.5.9 Set Intel Filters — Packet Addition Decision Filter Command (Intel Command
0x02, Filter Parameter 0x61)
This command is not supported anymore. Use the Set Intel Filters - Packet Addition Extended Decision
Filter Command (Intel Command 0x02, Filter parameter 0x68 - Section 10.6.3.5.18) instead.
Bits
Bytes 31:24 23:16 15:08 07:00
00...15 NC-SI Header
16...19 Manufacturer ID (Intel 0x157)
20... 0x02 0x11 Filter Data Group Filter Data 1
... Filter Data N
Table 10-36. Filter Data Group
Code
Bytes
programmed
Filter Data
Length
0x0 bytes 0-29 1 - 30
0x1 bytes 30-59 1 - 30
0x2 bytes 60-89 1 - 30
0x3 bytes 90-119 1 - 30
0x4 bytes 120-127 1 - 8
Bits
Bytes 31:24 23:16 15:08 07:00
00...15 NC-SI Header
16...19 Response Code Reason Code
20...23 Manufacturer ID (Intel 0x157)
24...25 0x02 0x11