Data Sheet

System Manageability—Ethernet Controller I210
679
10.5.9.2.8 Get Common Filters Command
The MC uses this command to get the common filters setting. This data can be configured when using
Set Common Filters command. The first transaction is a block write that alerts that the MC wants to
read the filters configuration. The second transaction is block read that read the configuration.
Block write transaction:
Following the block write the MC should issue a block read that reads the filter settings:
Data returned from the I210:
0x0E 4 Data 4:3: PXE FW version
MajorVersion.MinorVersion.Build.SubBuild
0x0F 4 Data 4:3: iSCSI FW version
0x10 4 Data 4:3: uEFI FW version
0xFE 2 Wrong parameter request
Returned by the I210 only. This parameter is
returned on read transaction, if in the previous read
command the MC sets a parameter that is not
supported by the I210.
0xFF 2 The I210 is not ready
Returned by the I210 only, on read parameters
command when the data that should have been
read is not ready. This parameter has no data. The
MC should retry the read transaction.
This value is also returned if the byte count is illegal
or if the read command is not preceded by a write
command.
Function Command Byte count Data
Get Common Filters 0xD3 1 0x00
Function Command
Get Common filters 0xD3
Function
Byte
Count
Command Data 1 Data 2:4 5:10 Data 11 Data 12
Data 13
Data
14:17
Get Common
Filters
18 0xD3 0
Receive
Control -
see
Table 10-
14
MAC
Addres
s
MC Alert
Address
Interface
Data Byte
Alert
Value
Byte
IPv4
Address
Table 10-25. Get Controller Information data