Data Sheet

ManualsBrandsIntel ManualsComputing & OfficeIntel Intel Ethernet Server Adapter I210-T1 - Network adapter 1 Gbps LAN (10/100/1000 Mbps), PCI-Express

671

672

673

674

675

676

677

678

679

680

System Manageability—Ethernet Controller I210

677

10.5.9.2.6 Read Receive Enable Configuration Command

The MC uses this command to read the receive configuration data. This data can be configured when

using Receive Enable command or through the Flash.

Read Receive Enable Configuration command format (SMBus Read Block) is as follows:

Data returned from the I210:

Parameter # Parameter Data

Filters Enable 0x01 None

MNGONLY Configuration 0x0F None

Flex Filter Enable Mask and Length 0x10 None

Flex Filter Data 0x11

Data 2 — Group of Flex Filter’s Bytes:

0x0 = bytes 0-29

0x1 = bytes 30-59

0x2 = bytes 60-89

0x3 = bytes 90-119

0x4 = bytes 120-127

Decision Filters 0x61 This command is obsolete. Please use 0x68 instead.

VLAN Filters 0x62

One byte to define the accessed VLAN tag filter (MAVTV)

Data 2 — VLAN Filter number

Flex Ports Filters 0x63

One byte to define the accessed manageability flex port filter (MFUTP).

Data 2 — Flex Port Filter number

IPv4 Filter 0x64

One byte to define the accessed IPv4 address filter (MIPAF)

Data 2 — IPv4 address filter number

IPv6 Filters 0x65

One byte to define the accessed IPv6 address filter (MIPAF)

Data 2 — Pv6 address filter number

MAC Filters 0x66

One byte to define the accessed MAC address filters pair (MMAL, MMAH)

Data 2 — MAC address filters pair number (0 - 3)

EtherType Filters 0x67

1 byte to define Ethertype filters (METF)

Data 2 — METF filter index (valid values are 0 - 3)

Extended Decision Filter 0x68

1 byte to define the extended decisions filters (MDEF_EXT & MDEF)

Data 2 — MDEF filter index (valid values are 0 - 6)

Management Special Filter Modifiers 0x69 No data

Wrong parameter request 0xFE

Returned by the I210 only. This parameter is returned on read transaction, if

in the previous read command the MC sets a parameter that is not supported

by the I210.

The I210 is not ready 0xFF

Returned by the I210 only, on read parameters command when the data that

should have been read is not ready. This parameter has no data.

This value is also returned if the byte count is illegal or if the read command is

not preceded by a write command.

Function Command

Read Receive Enable 0xDA

Function

Byte

Count

Data 1

(Op-

Code)

Data 2

Data

…

Data

…

Data