Data Sheet

Ethernet Controller I210 —System Manageability
668
Function Command
Byte
Count
Data 1 Data 2:4 5:10 Data 11 Data 12
Data 13
Data
14:29
Set Common
Filters
0xC2 29 Opcode = 0
Receive
Control -
see
Table 10-
14
MAC
Addres
s
MC Alert
Address
Interface
Data Byte
Alert
Value
Byte
IPv6
Address
Table 10-14. Set Common Filters Receive Control Bytes
Byte Bit Description Description
1
0 RCV_EN
Receive TCO Packets Enabled. When this bit is set it enables the receive
flow to the manageability block.
This bit should be set only if at least one of EN_BMC2O or EN_BMC2NET
bits are set.
1EN_STA
Enable Status Reporting.
0b: Disable status reporting.
1b: Enable status reporting.
2 Auto ARP
Automatically respond to ARP packets. Ignored in IPv6 mode. If this bit
is set, broadcast ARP packets will be handled by the I210 and ARP
requests to the IP address set in the command will be responded.
Note: Mutually exclusive to Configure ARP/ Neighborhood Filter bit.
If this bit is set, the IP address must be valid.
This bit is ignored if RCV_EN is cleared.
3 Enable Xsum Filtering to MNG
When this bit is set, only packets that pass the L3 and L4 checksum are
send to the manageability block.
This bit is ignored if RCV_EN is cleared
4:5 Reserved
6:7 Notification Method
Notification Method. Define the notification method the I210 uses.
00b: SMBUS Alert.
01b: Asynchronous notify.
10b: Direct receive.
11b: Not supported.