Data Sheet

Ethernet Controller I210 —System Manageability
666
Flex Port Filters 0x63
Three bytes are required to load the manageability flex port filters.
Data 2: Flex port filter number.
Data 3: MSB of flex port filter.
Data 4: LSB of flex port filter.
Data 5:
Bit 0: Match UDP ports
Bit 1: Match TCP ports
Bit 2: Match Destination port (0) or Source Port (1).
If Data 5 is not present, the match is done on TCP and UDP destination ports (legacy
behavior).
IPv4 Filters 0x64
Five bytes are required to load the IPv4 address filter.
Data 2: IPv4 address filter number (3:0).
Data 3: LSB of IPv4 address filter.
…
Data 6: MSB of IPv4 address filter.
IPv6 Filters 0x65
17 bytes are required to load the IPv6 address filter.
Data 2 — IPv6 address filter number (3:0).
Data 3 — LSB of IPv6 address filter.
…
Data 18 — MSB of IPv6 address filter.
MAC Filters 0x66
Seven bytes are required to load the MAC address filters.
Data 2 — MAC address filters pair number (3:0).
Data 3 — MSB of MAC address.
…
Data 8: LSB of MAC address.
EtherType Filters 0x67
5 bytes to load Ethertype Filters (METF)
Data 2 — METF filter index (valid values are 0, 1, 2, 3)
Data 3 — MSB of METF
...
Data 6 — LSB of METF
Extended Decision Filter 0x68
9 bytes to load the extended decision filters (MDEF_EXT & MDEF)
Data 2 — MDEF filter index (valid values are 0...5)
Data 3 — MSB of MDEF_EXT (DecisionFilter1)
....
Data 6 — LSB of MDEF_EXT (DecisionFilter1)
Data 7 — MSB of MDEF (DecisionFilter0)
....
Data 10 — LSB of MDEF (DecisionFilter0)
The command shall overwrite any previously stored value
Management Special Filter
Modifiers
0x69
4 bytes to load the Management Special Filter Modifiers
Data 2 - MSB of MSFM Register
...
Data 5- LSB of MSFM Register
Table 10-12. Management Receive Filter Parameters
Parameter Number Parameter Data