Data Sheet

Ethernet Controller I210 —Flash Map
224
6.7.3.13 MCTP UUID - Time High and Version (Offset 0x0C)
6.7.3.14 MCTP UUID - Clock Seq (Offset 0x0D)
6.7.3.15 MCTP UUID - Node (Offset 0x0E-0x10)
6.7.3.16 OEM IANA (Offset 0x11)
6.7.3.17 NC-SI Over MCTP Message Types (Offset 0x12)
Bits Name
Default
HW Mode
Description Reserved
15:0 Time High and Version Byte 7 & 8 of UUID as defined in DSP0236.
Bits Name
Default
HW Mode
Description Reserved
15:0 Clock Seq and Reserved Byte 9 & 10 of UUID as defined in DSP0236.
Bits Name
Default
HW Mode
Description Reserved
15:0 Node Should contain the same value as the factory station MAC address.
Bits Name
Default
HW Mode
Description
Reserved
15:0 OEM IANA Number 0x0
If not zero and not 0x157, the I210 accepts additional OEM
commands with this IANA number. These commands are accepted
only if the OEM Flash Structure Pointer (Section 6.7) is valid. The
set of commands accepted depends on the IANA value in this
field.
The regular Intel OEM commands are accepted only with IANA
0x157.
Bits Name
Default
HW Mode
Description
Reserved
15:8
NC-SI Command Packet
Type
0x2
Defines the MCTP packet type used to identify NC-SI control
packets.
Note: The most significant bit is the IC bit and should be set to
zero.
No
7:0
NC-SI Pass Through
Packet Type
0x3
Defines the MCTP packet type used to identify NC-SI pass through
packets.
Note: The most significant bit is the IC bit and should be set to
zero.
No