Datasheet

Datasheet 27
Electrical Specifications
5. 0.24 V is defined at 20% of nominal V
TT
of 1.2 V.
6. The TAP signal group must meet the signal quality specifications.
7. The maximum output current is based on maximum current handling capability of the buffer and is
not specified into the test load.
8. Leakage to V
SS
with land held at V
TT
.
9. Leakage to V
TT
with land held at 300 mV.
Table 13. VTTPWRGD DC Specifications
Symbol Parameter Min Typ Max Unit
V
IL
Input Low Voltage — — 0.3 V
V
IH
Input High Voltage 0.9 — — V
Table 14. BSEL[2:0] and VID[5:0] DC Specifications
Symbol Parameter Max Unit Notes
1, 2
NOTES:
1. Unless otherwise noted, all specifications in this table apply to all processor frequencies.
2. These parameters are not tested and are based on design simulations.
R
ON
(BSEL) Buffer On Resistance 120 Ω -
R
ON
(VID) Buffer On Resistance 120 Ω -
I
OL
Max Land Current 2.4 mA -
I
LO
Output Leakage Current 200 µA
3
3. Leakage to V
SS
with land held at 1.2 V.
V
TOL
Voltage Tolerance V
TT
(max) V -
Table 15. BOOTSELECT DC Specifications
Symbol Parameter Min Typ Max Unit Notes
V
IL
Input Low Voltage — — 0.24 V
1
NOTES:
1. These parameters are not tested and are based on design simulations.
V
IH
Input High Voltage 0.96 — — V
1