Datasheet

Thermal Sensor Registers (D31:F6)
Intel® Xeon® Processor D-1500 Product Family 555
Datasheet - Volume 1 of 4: Integrated Platform Controller Hub
March 2015
16.2.11 PHL—Intel® Xeon® Processor D-1500 Product Family Hot
Level Register
Offset Address: TBARB+60h Attribute: RO, R/W
Default Value: 0000h Size: 16 bit
16.2.12 PHLC—PHL Control Register
Offset Address: TBARB+62h Attribute: RO, R/W
Default Value: 00h Size: 8 bit
16.2.13 TAS — Thermal Alert Status Register
Offset Address: TBARB+80h Attribute: RO, R/W
Default Value: 00h Size: 8 bit
29 TT Enable (TTEN) – R/W. When set the thermal throttling states are enabled. At reset, BIOS must
set bits 28:0 and then do a separate write to set bit 29 to enable throttling. SW may set bit 31 at
the same time it sets bit 29 if it wishes to lock the register. If SW wishes to change the values of
28:0, it must first clear the TTEN bit, then change the values in 28:0; and then re-enable TTEN. It
is legal to set bits 31, 30 and 29 with the same write.
This bit must not be set by SW until SW has already enabled the thermal
sensor(TSEL.ETS =’1’).
If TTEN is written to ‘0’, after having been enabled, then Intel® Xeon® Processor D-1500 Product
Family may stay in the throttling state it was in at the moment TTEN is disabled. There is no intent
that the sensor be enabled for a while and then disabled and left off. It may be disabled temporarily
while changing the register values, but it should not be left in the disabled state.
28:20 T2 Level (T2L) – R/W. When TTEN = 1 AND TSE = ‘1’ AND (T2L >= TSR[8:0] > T1L), then the
system is in T2 state.
When TTEN = 1 AND TSE = ‘1’ AND (TSR[8:0] > T2L), then the system is in T3 state.
Note: The T3 condition overrides PMSync[13] and forces the system to T3 if both cases are true.
SW NOTE:T2L must be programmed to a value greater than T1L if TTEN=’1’
19 Reserved
18:10 T1 Level (T1L) – R/W. When TTEN = 1 AND TSE = 1 AND (T1L >= TSR[8:0] > T0L), then the
system is in T1 state.
SW NOTE:T1L must be programmed to a value greater than T0L if TTEN=’1’
9Reserved
8:0 T0 Level (T0L) – R/W. When TEMP.TSR[8:0] <= T0L OR TT.Enable is ‘0’ OR TSE 0’, then the
system is in T0 state.
Bit Description
Bit Description
15 PHL Enable (PHLE) – R/W. When set and the current temperature reading, TSR, is greater than
PHLL, then the TEMP_ALERT# pin will be asserted (active low).
14:9 Reserved
8:0 PHL Level (PHLL) – R/W. Temperature value used for TEMP_ALERT# pin.
Bit Description
7:1 Reserved
0 PHL Lock – R/W. When written to a ‘1’, then both PHL and PHLC are locked
Bit Description
7:2 Reserved