Installation Instructions

ManualsBrandsIntel ManualsElectronicsIntel Wireless-AC 9260

Regulatoty Compliance

Product Name

Intel® Wireless-AC 9260

Model No.

9260NGW

FCC ID.

XHU-GCU040864

IC ID.

8439A-GCU040864

Antenna List

No.

Manufacturer

Part No.

Antenna Type

Peak Gain

Molex

1461531050

Dipole Antenna

3.2dBi for 2.4GHz

4.25dBi for 5.15~5.85GHz

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/ TV technician for help.

CAUTION:

Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate

the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

RF exposure warning

This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this

transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or

operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna

installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

End Product Labeling

This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may

be maintained between the antenna and users. The final end product must be labeled in a visible area with the

following: "Contains FCC ID: XHU-GCU040864 ” and "Contains IC: 8439A-GCU040864 “

Summary of content (2 pages)

PAGE 1
Regulatoty Compliance Product Name Intel® Wireless-AC 9260 Model No. 9260NGW FCC ID. XHU-GCU040864 IC ID. 8439A-GCU040864 Antenna List No. Manufacturer 1 Molex Part No. Antenna Type Peak Gain 1461531050 Dipole Antenna 3.2dBi for 2.4GHz 4.25dBi for 5.15~5.85GHz FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user. 1) This device is intended for OEM integrators only. 2) Please see the full Grant of Equipment document for other restrictions.