Installation Instructions

Radio Frequency Exposure
This device meets the U.S. Federal Communications Commission's (FCC) requirements for
exposure to radio waves and is designed and manufactured not to exceed the FCC's emission
limits for exposure to radiofrequency (RF) energy. To comply with FCC RF exposure compliance
requirements, this device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Specific Absorption Rate (SAR) Information
This device is also designed to meet the requirements for exposure to radio waves established
by the FCC.
The SAR limit adopted by the FCC is 1.6 W/kg averaged over one gram of tissue. The highest
SAR value reported to the FCC for this device type complies with this limit.
Regulatory Information: Canada
Innovation, Science and Economic Development Canada (ISED), Class B
This Class B digital apparatus complies with Canadian ICES-003. CAN ICES-3(B)/NMB-3(B).
Notice: ISED regulations provide that changes or modifications not expressly approved by the
manuafcture could void your authority to operate this equipment.
ISED Notices
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
Les dispositifs fonctionnant dans la bande de 5 150 à 5 250 MHz sont réservés uniquement pour
une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de
satellites mobiles utilisant les mêmes canaux.