Data Sheet

ManualsBrandsIntel ManualsDevelopment Kit Add-onsDevelopment board 1 pc(s)

Table 27. USB Ports

Port Description

P1 • USB Standard A Plug.

• Connects to USB host

• Used for both USB signals and USB VBUS 5 V

P2 • Complementary USB Standard A plug for additional USB VBUS 5 V power.

• No signal connection.

P3 • USB Mini-B Plug

• Connected to USB Port J17

When P1 and P2 are plugged into USB Host ports at the same time, it can supply up to

1A current to the Intel Cyclone 10 LP FPGA Evaluation Board.

Figure 11. USB Y-Cable

AC/DC Adapter Power

The DC Jack uses Wurth Elektronik P/N 694106301002 as power input connector.

The required DC mate plug is required to meet the parameters below

• Inner Diameter (ID): 2.1 mm

• Outer Diameter (OD): 5.5 mm

• Voltage: 5 V

• Center Polarity: Positive (5 V)

Caution:

Use 5 V adapter for DC Jack J12 only. Components on the board can get damaged by

power supplies with greater voltage.

4 Evaluation Board Components

UG-20082 | 2018.02.05

Intel

Cyclone

10 LP FPGA Evaluation Kit User Guide

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.