Specifications

Shield pin configuration
6.3 LEDs
The Intel® Edison kit for Arduino has three LEDs. (See Figure 5 for locations.)
• DS1 is the reset LED. It will turn on when the Intel® Edison processor is running. When the processor is in
reset and asserting RESET_OUT# low, it will turn off.
• DS2 is the standard LED on the Arduino* board. It runs using the ‘blink’ code or whenever Digital I/O 13 is
asserted High. It can be used as an indicator under direct control.
• DS3 is the battery charging LED. It will turn on when the LTC4067 is charging an attached battery.
§
Intel® Edison Kit for Arduino*
Hardware Guide December 2014
22 Document Number: 331191-004