Guide
Mechanical Drawings
98 Intel® Xeon® Processor E7 2800/4800/8800 v2 Product Family
Thermal/ Mechanical Specifications and Design Guide
Figure G-7. ILM Mechanical Drawing - G56693 Rev 2 (Sheet 2 of 4)
13
4
5678
B
C
D
A
123
4
5678
B
C
D
A
2200 MISSION COLLEGE BLVD.
P.O. BOX 58119
SANTA CLARA, CA 95052-8119
R
61
75.82
61
75.72
4.4
5.55
46
47
2.63
+0.25
0
2.63
+0.25
0
G56693 2 2
DWG. NO SHT. REV
THIS DRAWING CONTAINS INTEL CORPORATION CONFIDENTIAL INFORMATION. IT IS DISCLOSED IN CONFIDENCE AND ITS CONTENTS
MAY NOT BE DISCLOSED, REPRODUCED, DISPLAYED OR MODIFIED, WITHOUT THE PRIOR WRITTEN CONSENT OF INTEL CORPORATION.
SHEET 2 OF 4
DO NOT SCALE DRAWING
SCALE: 1:1
PMCI
2G56693D
REV
DRAWING NUMBER
SIZE
DEPARTMENT
NOTES; UNLESS OTHERWISE SPECIFIED:
1. REFERENCE DOCUMENTS
ASME Y14.5M-1994 - STANDARD DIMENSION AND TOLERANCES
UL1439 - UL SHARP EDGE TESTING
2. MATERIAL: MAY USE ENGINEERING APPROVED EQUIVALENT.
A) TYPE: 301 STAINLESS STEEL, 0.8MM+/- 0.05 THK.
B) CRITICAL MECHANICAL PROPERTIES:
TENSILE YIELD STRENGTH (ASTM D638) >= 758 MPa
MODULUS OF ELASTICITY (ASTM D638) >= 193 GPa
C) PLATING: NONE.
D) HEAT TREATING: NONE
3. BURR HEIGHTS SHALL NOT EXCEED 0.08MM.
4. SHARP CORNERS MUST BE CHAMFERED OR ROUNDED TO 0.25MM MAX.
5. UNSPECIFIED SURFACES TO BE FLAT WITHIN 0.125MM PER 25.4MM.
HINGE CLEVIS
ACTIVE CLEVIS
NOTES; UNLESS OTHERWISE SPECIFIED:
1. REFERENCE DOCUMENTS
ASME Y14.5M-1994 - STANDARD DIMENSION AND TOLERANCES
2. MATERIAL: MAY USE ENGINEERING APPROVED EQUIVALENT.
A) TYPE:301 STAINLESS STEEL 1.5MM # .08
B) CRITICAL MECHANICAL PROPERTIES:
TENSILE YIELD STRENGTH (ASTM D638) >= 758 MPa
MODULUS OF ELASTICITY (ASTM D638) >= 193 GPa
C) PLATING: NONE.
3. BURR HEIGHTS SHALL NOT EXCEED .15MM.
4. SHARP CORNERS MUST BE CHAMFERED, OR ROUNDED TO 0.25MM RADIUS MAX.
5. UNSPECIFIED SURFACES TO BE FLAT WITHIN 0.125MM.
6 PERMANENTLY MARK COSMETIC TEXT IN BLACK WHERE SHOWN. MARKING MUST BE
CLEARLY VISIBLE WHEN ILM COVER PART G20923-00X IS INSTALLED.
7 PERMANENTLY MARK PIN 1 INDICATOR IN BLACK APPROXIMATELY WHERE SHOWN
LOAD PLATE