Guide

Mechanical Drawings
110 Intel® Xeon® Processor E7 2800/4800/8800 v2 Product Family
Thermal/ Mechanical Specifications and Design Guide
Figure G-19. Processor Heatsink Spring Mechanical Drawing - E86113 Rev C
13
4
5678
B C D
A
123
4
5678
B C D
A
A
A
2200 MISSION COLLEGE BLVD. P.O. BOX 58119 SANTA CLARA, CA 95052-8119
R
12.70 [0.500]
FREE HEIGHT
O.D. 7.62
+0.08 -0.13
0.300
+0.003 -0.005
[]
1.100 [0.0433]
WIRE DIA.
5.50
+0.30 0
0.217
+0.011 -0.000
[]
I.D. 5.42
+0.08 -0.13
0.213
+0.003 -0.005
[]
E86113 1 C
DWG. NO SHT. REV
SHEET 1 OF 1DO NOT SCALE DRAWINGSCALE: 1
CE86113D
REVDRAWING NUMBERSIZE
SPRING, COMPRESSION, PRE-LOAD
TITLE
EASD / PTMI
DEPARTMENT
SEE NOTESSEE NOTES
FINISHMATERIAL DATEAPPROVED BY 11/16/09D. LLAPITAN DATECHECKED BY 11/15/09N. ULEN DATEDRAWN BY 11/15/09N. ULEN DATEDESIGNED BY
UNLESS OTHERWISE SPECIFIED INTERPRET DIMENSIONS AND TOLERANCES IN ACCORDANCE WITH ASME Y14.5-1994 DIMENSIONS ARE IN MILLIMETERS TOLERANCES: .X # .5 Angles # 1.0 $
.XX # 0.25 .XXX # 0.127
THIRD ANGLE PROJECTION
REVISION HISTORY
ZONE REV DESCRIPTION DATE APPROVED
- A SUPPLIER FEEDBACK 11/15/09 -
B
ALL SPRING SPECIFICATIONS UPATED. SEE NOTE 3. 12/08/09
NOTE 3 C UPDATED SPRING STIFFNESS AND COIL INFO 01/14/10
THIS DRAWING CONTAINS INTEL CORPORAT ION CONFIDENTIAL INFORMATION. IT IS DISCLOSED IN CONFIDENCE AND ITS CONT ENTS MAY NOT BE DISCLOSED, REPRODUCED, DI SPLAYED OR MODIFIED, WITHOUT THE PRI OR WRITTEN CONSENT OF INTEL CORPORAT ION.
NOTES: 1. THIS DRAWING TO BE USED IN CONJUNCTION WITH SUPPLIED 3D DATABASE. ALL DIMENSIONS AND TOLERANCES ON THIS DRAWING TAKE PRECEDENCE OVER SUPPLIED DATABASE. 2. PRIMARY DIMENSIONS STATED IN MILLIMETERS. [BRACKETED] DIMENSIONS STATED IN INCHES. 3. SPRING RATE: K=15.80 +/- 1.5 N/MM [K=90.2 +/- 9.0 LBF/IN] 4 FREE HEIGHT: 12.7 MM [0.500 IN] SOLID HEIGHT: 5.5 MM [0.217 IN] WIRE DIAMETER: 1.1 MM [0.043 IN] TOTAL COILS: 5.0 (ONLY TOTAL COILS SHOWN IN THIS DRAWING) ACTIVE COILS: 3.0 ENDS: GROUND & CLOSED TURN: LEFT HAND (AS SHOWN IN VIEWS) MATERIAL: MUSIC WIRE, ASTM A228 OR JIS-G-3522 FINISH: ZINC PLATED OTHER GEOMETRY: PER THIS DRAWING
4 CRITICAL TO FUNCTION DIMENSION
4
4
4
FREE HEIGHT
SOLID HEIGHT
4
SECTION A-A