Datasheet

Compatible Intel® Ethernet Converged Network Adapter Product Codes
Conguration No. of Ports Single Pack Bulk 5 Pack
Intel® Ethernet Converged Network Adapter X520-QDA1 1 X520QDA1
Intel® Ethernet Converged Network Adapter XL710-QDA1 1 XL710QDA1 XL710QDA1BLK
Intel® Ethernet Converged Network Adapter XL710-QDA2 2 XL710QDA2 XL710QDA2BLK
Optical Characteristics
(T
OP
= 0 °C to 70 °C, VCC=3.15 to 3.45 V)
Parameter Symbol Min Typ Max Unit Note
Transmitter (per Lane)
Signaling Speed per Lane 10.5 Gb/s 1
Center Wavelength 840 860 nm
RMS Spectral Width SW 0.65 nm
Average Launch Power per Lane TXP
X
-7.6 -1.0 dBm
Transmit OMA per Lane TxOMA -5.6 3.0 dBm 2
Difference in Power between any two lanes (OMA) DP
X
4.0 dB
Peek Power per Lane PP
X
4.0 dBm
Launch Power (OMA) minus TDP per Lane P-TDP -6.5 dBm
TDP per Lane TDP 3.5 dBm
Optical Extinction Ratio ER 3.0 dB
Optical Return Loss Tolerance ORL 12 dB
Encircled Flux FLX
> 86% at 19 um
< 30% at 4.5 um
dBm
Average launch power of OFF transmitter per lane -30 dBm
Reletive Intensity Noise RIN -128 dB/Hz
Transmitter eye mask denition
(X1, X2, X3)
(Y1, Y2, Y3)
0.23, 0.34, 0.43
0.27, 0.35, 0.4
Receiver (per Lane)
Signaling Speed per Lane 10.5 GBd 3
Center Wavelength 840 860 nm
Damage Threshold DT 3.4 dBm
Average Receive Power per Lane RXP
X
-9.5 2.4 dBm
Receive Power (OMA) per Lane RxOMA 3.0 dBm
Stressed Reveiver Sensitivity (OMA) per Lane SRS -5.4 dBm
Peak Power per Lane PP
X
4 dBm
Receiver Reectance R -12 dB
Conditions of stressed receiver sensitivity test:
Vertical Eye Closure Penalty (VECP) per lane
Stressed eye J2 jitter per lane
Stressed eye J9 jitter per lane
OMA of each aggressor lane
1.9
0.3
0.47
-0.4
dB
UI
UI
dBm
Rx jitter tolerance in OMA per lane Max -5.4 dBm
Conditions of receiver jitter tolerance test:
Jitter frequency and peak-to-peak amplitude
Jitter frequency and peak-to-peak amplitude
OMA of each aggressor lane
(75, 5)
(357, 1)
-0.4
KHz, UI
KHz, UI
dBm
Loss of Optic Signal (LOS) De-Assert LOS
D
-12 dBm
Loss of Optic Signal (LOS) Assert LOS
A
-30 dBm
Loss of Optic Signal (LOS) Hysteresis 0.5 dBm
Notes:
1. Transmitter consists or four lasers operating at a maximum rate of 10.5 Gb/s each.
2. Even if TDP is < 0.9 dB, the OMA min must exceed this value.
3. Receiver consists of four photodetectors operating at a maximum rate of 10.5 Gb/s each.
2