Intel Desktop Board DG45FC Technical Product Specification

Product Description
35
1.12.2.2 Fan Headers
The function/operation of the fan headers is as follows:
• The fans are on when the board is in the S0 state.
• The fans are off when the board is off or in the S3, S4, or S5 state.
• The processor fan header is wired to a fan tachometer input. The processor fan
header and front fan header both have independent tachometer input to the
hardware monitoring and fan control device. All fan headers support closed-loop
fan control that can adjust the fan speed according to thermal conditions.
• All fan headers have a +12 V DC connection.
For information about Refer to
The locations of the fan headers and thermal sensors Figure 6, page 30
The signal names of the processor fan header Table 16, page 47
The signal names of the chassis fan headers Table 15, page 46
1.12.2.3 LAN Wake Capabilities
CAUTION
For LAN wake capabilities, the +5 V standby line from the power supply must be
capable of providing adequate +5 V standby current. Failure to provide adequate
standby current when implementing LAN wake capabilities can damage the power
supply.
LAN wake capabilities enable remote wake-up of the computer through a network.
The LAN subsystem PCI bus network adapter monitors network traffic at the Media
Independent Interface. Upon detecting a Magic Packet* frame, the LAN subsystem
asserts a wake-up signal that powers up the computer. Depending on the LAN
implementation, the board supports LAN wake capabilities with ACPI in the following
ways:
• The PCI Express WAKE# signal
• The PCI bus PME# signal for PCI 2.3 compliant LAN designs
⎯ By Ping
⎯ Magic Packet
• The onboard LAN subsystem