Product guide
Table Of Contents
- Intel® Desktop Board DP55WG Product Guide
- Revision History
- Preface
- Contents
- 1 Desktop Board Features
- Supported Operating Systems
- Desktop Board Components
- Processor
- Main Memory
- Intel® P55 Express Chipset
- Audio Subsystem
- LAN Subsystem
- USB 2.0 Support
- Serial ATA Support
- Legacy I/O
- Expandability
- BIOS
- Hardware Management
- Power Management
- Onboard Power Button
- Processor and Voltage Regulator LEDs
- Back to BIOS Button
- Speaker
- Battery
- Real-Time Clock
- 2 Installing and Replacing Desktop Board Components
- Before You Begin
- Installation Precautions
- Installing the I/O Shield
- Installing and Removing the Desktop Board
- Installing and Removing a Processor
- Installing and Removing System Memory
- Installing and Removing PCI Express x16 Graphics Cards
- Connecting the Serial ATA (SATA) Cables
- Connecting to the Internal Headers
- Connecting to the Audio System
- Connecting Chassis Fan and Power Supply Cables
- Setting the BIOS Configuration Jumper
- Clearing Passwords
- Replacing the Battery
- 3 Updating the BIOS
- 4 Configuring for RAID Using Intel® Matrix Storage Technology
- A Error Messages and Indicators
- B Regulatory Compliance
Installing and Replacing Desktop Board Components
51
Alternate Front Panel Power LED Header
Figure 27, F shows the location of the alternate front panel power LED header. Pins 1
and 3 of this header duplicate the signals on pins 2 and 4 of the front panel header. If
your chassis has a three-pin power LED cable, connect it to this header. Table 9
shows
the pin assignments for the alternate front panel header.
Table 9. Alternate Front Panel Power LED Header Signal Names
Pin Signal Name In/Out
1 Front panel green LED Out
2 No pin
3 Front panel yellow LED Out
USB 2.0 Headers
Figure 27, G shows the location of the USB 2.0 headers. Table 10 shows the pin
assignments and signal names for each USB 2.0 header. Each USB header can be
used to connect two USB devices.
Table 10. USB 2.0 Header Signal Names
USB Port A USB Port B
Pin Signal Name Pin Signal Name
1 Power (+5 V) 2 Power (+5 V)
3 D- 4 D-
5 D+ 6 D+
7 Ground 8 Ground
9 Key 10 No Connection
Note: USB ports may be assigned as needed.
NOTE
Computer systems that have an unshielded cable attached to a USB port might not
meet FCC Class B requirements, even if no device or a low-speed USB device is
attached to the cable. Use a shielded cable that meets the requirements for a
full-speed USB device.