Datasheet

Platform Management Functional Overview Intel
®
Server Board S2400GP TPS
Revision 1.01
Intel order number G50295-002
86
Table 20. Diagnostic Data
Category
Data
Internal BMC Data
BMC uptime/load
Process list
Free Memory
Detailed Memory List
Filesystem List/Info
BMC Network Info
BMC Syslog
BMC Configuration Data
External BMC Data
Hex SEL listing
Human-readable SEL listing
Human-readable sensor listing
External BIOS Data
BIOS configuration settings
POST codes for the two most recent boots
System Data
SMBIOS table for the current boot
256 bytes of PCI config data for each PCI device
Memory Map (EFI and Legacy) for current boot
Table 21. Additional Diagnostics on Error
Category
Data
System Data
First 256 bytes of PCI config data for each PCI
device
PCI error registers
MSR registers
MCH registers
6.12.16 Data Center Management Interface (DCMI)
The DCMI Specification is an emerging standard that is targeted to provide a simplified
management interface for Internet Portal Data Center (IPDC) customers. It is expected to
become a requirement for server platforms which are targeted for IPDCs. DCMI is an IPMI-
based standard that builds upon a set of required IPMI standard commands by adding a set of
DCMI-specific IPMI OEM commands. Intel
®
S1400/S1600/S2400/S2600 Server Platforms will
be implementing the mandatory DCMI features in the BMC firmware (DCMI 1.1 Errata 1
compliance). Please refer to DCMI 1.1 errata 1 specification for details. Only mandatory
commands will be supported. No support for optional DCMI commands. Optional power
management and SEL roll over feature is not supported. DCMI Asset tag will be independent of
baseboard FRU asset Tag. Please refer table DCMI Group Extension Commands for more
details on DCMI commands.
6.12.17 Lightweight Directory Authentication Protocol (LDAP)
The Lightweight Directory Access Protocol (LDAP) is an application protocol supported by the
BMC for the purpose of authentication and authorization. The BMC user connects with an LDAP
server for login authentication. This is only supported for non-IPMI logins including the
embedded web UI and SM-CLP. IPMI users/passwords and sessions are not supported
over LDAP.
LDAP can be configured (IP address of LDAP server, port, and so on.) through the BMC’s
Embedded Web UI. LDAP authentication and authorization is supported over the any NIC