User Manual
Table Of Contents
- Intel® Desktop Boards D815EEA2, D815EPEA2, D815EFV, and D815EPFV Product Guide
- Revision History / Disclaimer
- Contents
- 1 Desktop Board Features
- 2 Installing and Replacing Desktop Board Components
- Before You Begin
- Installing and Removing Memory
- Installing and Removing the AGP Card Retention Mechanism
- Installing and Removing AGP and GPA Cards
- Installing the I/O Shield
- Installing the Desktop Board
- Installing a Processor
- Removing the Processor
- Installing a 1 GHz Processor Fan Heatsink
- Removing the 1 GHz Processor Fan Heatsink
- Replacing the Battery
- Setting the BIOS Configuration Jumper
- Clearing the Passwords
- 3 Updating the BIOS
- 4 Using the Setup Program
- 5 Technical Reference
- A Error Messages and Indicators
- B Regulatory Compliance
Installing and Replacing Desktop Board Components
47
Connecting the IDE Cable
The Intel
®
boxed desktop board package includes two IDE cables. Both are capable of connecting
two drives to the desktop board. The 40-contact cable supports the Ultra DMA-33 transfer
protocol. The 40-contact 80-conductor cable supports ATA-66 and ATA-100 transfer protocols
and is backward compatible with drives using slower IDE transfer protocols.
✏
NOTE
ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer
protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are
attached to the same cable, the maximum transfer rate between the drives can be reduced to that of
the slowest drive.
✏
NOTE
Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device. For
example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive.
For the cable to function correctly:
• Attach the cable end with the single connector (A), which is blue and labeled P1, to the
desktop board as shown in Figure 25.
• Attach the cable end with the two closely spaced connectors (B), which are gray and black and
are labeled P2 and P3, to the drives.
• If connecting only one IDE drive, be sure to connect the drive to the black connector (P3).
OM11159
A
B
Figure 25. Connecting the IDE Cable (the D815EEA2 Board Is Shown)