User Manual
Table Of Contents
- Intel® Desktop Boards D815EEA2, D815EPEA2, D815EFV, and D815EPFV Product Guide
- Revision History / Disclaimer
- Contents
- 1 Desktop Board Features
- 2 Installing and Replacing Desktop Board Components
- Before You Begin
- Installing and Removing Memory
- Installing and Removing the AGP Card Retention Mechanism
- Installing and Removing AGP and GPA Cards
- Installing the I/O Shield
- Installing the Desktop Board
- Installing a Processor
- Removing the Processor
- Installing a 1 GHz Processor Fan Heatsink
- Removing the 1 GHz Processor Fan Heatsink
- Replacing the Battery
- Setting the BIOS Configuration Jumper
- Clearing the Passwords
- 3 Updating the BIOS
- 4 Using the Setup Program
- 5 Technical Reference
- A Error Messages and Indicators
- B Regulatory Compliance
Intel Desktop Boards D815EEA2, D815EPEA2, D815EFV, and D815EPFV Product Guide
40
3. When properly aligned, each edge of the plastic clip should click into place. Hold the clip
handle (see Figure 19, A) and very slowly lower the handle until the clip secures the fan
heatsink to the processor socket.
OM11062
A
B
Figure 19. Lowering the Plastic Clip Handle