User Manual
Table Of Contents
- Intel® Desktop Boards D815EEA2, D815EPEA2, D815EFV, and D815EPFV Product Guide
- Revision History / Disclaimer
- Contents
- 1 Desktop Board Features
- 2 Installing and Replacing Desktop Board Components
- Before You Begin
- Installing and Removing Memory
- Installing and Removing the AGP Card Retention Mechanism
- Installing and Removing AGP and GPA Cards
- Installing the I/O Shield
- Installing the Desktop Board
- Installing a Processor
- Removing the Processor
- Installing a 1 GHz Processor Fan Heatsink
- Removing the 1 GHz Processor Fan Heatsink
- Replacing the Battery
- Setting the BIOS Configuration Jumper
- Clearing the Passwords
- 3 Updating the BIOS
- 4 Using the Setup Program
- 5 Technical Reference
- A Error Messages and Indicators
- B Regulatory Compliance
Installing and Replacing Desktop Board Components
39
Installing a 1 GHz Processor Fan Heatsink
To install a processor, follow the instructions given on page 36, Figure 13. Follow the instructions
below to install the fan heatsink on a processor 1 GHz or greater.
1. Attach the fan heatsink to the processor making sure the notch at the bottom of the heatsink is
aligned on the processor socket label side (see Figure 17, A).
OM11063
A
Figure 17. Attaching the Fan Heatsink Over the Processor
2. Making sure the handle is in the up position, place the plastic clip (see Figure 18, B) on the fan
heatsink (see Figure 18, C). The inset in Figure 18 (A) shows the heatsink notch location.
OM11064
B
C
A
Figure 18. Placing the Plastic Clip on the Fan Heatsink