D201GLY2 Technical Product Specification

Intel Desktop Board D201GLY2 Technical Product Specification

1.7.1 Serial Port

The serial port A connector is located on the back panel. The serial port supports data

transfers at speeds up to 115.2 kbits/sec with BIOS support.

For information about Refer to

The location of the serial port A connector Figure 7, page 37

1.7.2 Parallel Port

The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS

Setup program to set the parallel port mode.

For information about Refer to

The location of the parallel port connector Figure 7, page 37

1.7.3 Keyboard and Mouse Interface

PS/2 keyboard and mouse connectors are located on the back panel.



NOTE

The keyboard is supported in the bottom PS/2 connector and the mouse is supported

in the top PS/2 connector. Power to the computer should be turned off before a

keyboard or mouse is connected or disconnected.

For information about Refer to

The location of the keyboard and mouse connectors Figure 7, page 37

1.8 Audio Subsystem

The audio subsystem consists of the following devices:

• SiS964 Southbridge

• ADI AD1888 audio codec

The audio subsystem includes these features:

• Signal-to-noise ratio ≥ 90 dB

• Supports wake events (driver dependent)

• Mic in pre-amp that supports dynamic, condenser, and electret microphones

The audio subsystem supports the following audio interfaces:

• Front panel audio header, including pins for:

⎯ Line out

⎯ Mic in