Specification Update

MOBILE INTEL
®
CELERON
®
PROCESSOR at 466 MHz, 433 MHz, 400 MHz,
366 MHz, 333 MHz, 300 MHz, 266 MHz SPECIFICATION UPDATE
55
Table 3.6. Mobile Celeron
®
Processor Power Specifications
1
T
CASE
= 0 to T
CASE,max
; V
CC
= 1.6 V ±135 mV; V
CCP
= 1.8 V ±90 mV
Symbol Parameter Min Typ Max Unit Notes
dI
CC
/dt V
CC
power supply current slew rate 20 A/µs 6, 7
NOTES:
1. Unless otherwise noted, all specifications in this table apply to all processor frequencies.
2. A higher V
CC,MAX
is allowed when the processor is in a low power state to enable high efficiency, low current modes
in the power regulator.
3. I
CCP
is the current supply for the CMOS voltage references.
4. Not 100% tested. Specified by design/characterization.
5. I
CCx,max
specifications are specified at V
CC,max
, V
CCP,max
and 100° C and under maximum signal loading conditions.
I
CCx,max
specifications are not specified at V
CC,LP,max,
if that voltage specification is used then slightly higher
currents can be expected.
6. Based on simulations and averaged over the duration of any change in current. Use to compute the maximum
inductance and reaction time of the voltage regulator. This parameter is not tested.
7. Maximum values specified by design/characterization at nominal V
CC
and V
CCP
.
H2. Temperature Note For Thermal Power Specifications
In the Intel
®
Mobile Celeron
®
Processor in BGA Package at 333 MHz, 300 MHz and 266 MHz datasheet, Table
6.1 TDP notes should state “at 100
o
C
2, 3
” instead of “at 50
o
C
2, 3
”. Table Note 3 should state, “3. Not 100%
tested or guaranteed. The power specifications are composed of the current of the processor on the various
voltage planes. These currents are measured and specified at high temperature in Section 3.5. The 50° C
power specifications are determined by characterization of the processor currents at higher temperatures.”