Specification Update

Errata
48 Specification Update
AT86. Updating Code Page Directory Attributes without TLB Invalidation
May Result in Improper Handling of Code #PF
Problem: Code #PF (Page Fault exception) is normally handled in lower priority order
relative to both code #DB (Debug Exception) and code Segment Limit
Violation #GP (General Protection Fault). Due to this erratum, code #PF may
be handled incorrectly, if all of the following conditions are met:
• A PDE (Page Directory Entry) is modified without invalidating the
corresponding TLB (Translation Look-aside Buffer) entry
• Code execution transitions to a different code page such that both
o The target linear address corresponds to the modified PDE
o
The PTE (Page Table Entry) for the target linear address has an A
(Accessed) bit that is clear
•
One of the following simultaneous exception conditions is present following the
code transition
o Code #DB and code #PF
o Code Segment Limit Violation #GP and code #PF
Implication: Software may observe either incorrect processing of code #PF before code
Segment Limit Violation #GP or processing of code #PF in lieu of code #DB.
Workaround: None identified.
Status: For the steppings affected, see the Summary Tables of Changes.
AT87. Performance Monitoring Event MISALIGN_MEM_REF May Over Count
Problem: Performance monitoring event MISALIGN_MEM_REF (05H) is used to count
the number of memory accesses that cross an 8-byte boundary and are
blocked until retirement. Due to this erratum, the performance monitoring
event MISALIGN_MEM_REF also counts other memory accesses.
Implication: The performance monitoring event MISALIGN_MEM_REF may over count. The
extent of over counting depends on the number of memory accesses retiring
while the counter is active.
Workaround: None identified.
Status: For the steppings affected, see the Summary Tables of Changes.