User Manual

User Guide for NUC10i7FNHN, NUC10i5FNHN, NUC10i3FNHN
5
If you’re installing an 80mm M.2 SSD:
1. Remove the small silver screw from the 80mm (A) and 42mm (B) metal standoff on the
motherboard.
2. Align the small notch at the bottom edge of the M.2 card with the key in the connector.
3. Insert the bottom edge of the M.2 card into the connector (C).
4. Secure the card to the standoff with the small silver screw (D).
If you’re installing a 42mm M.2 SSD:
1. Remove the small silver screw from the metal standoff on the motherboard (A).
2. Align the small notch at the bottom edge of the M.2 card with the key in the connector.
3. Insert the bottom edge of the M.2 card into the connector (B).
4. Secure the card to the standoff with the small silver screw (C).
Install a 2.5” SSD or Hard Drive
The Intel NUC Kits NUC10i7FNHN, NUC10i5FNHN, and NUC10i3FNHN support an additional 2.5” Solid
State Drive (SSD) or Hard Disk Drive (HDD).