Data Sheet

Datasheet, Volume 1 of 2 125
Electrical Specifications
7.2.1.8 Vcc
ST
DC Specifications
Notes:
1. Unless otherwise noted, all specifications in this table are based on estimates and simulations or empirical data. These
specifications will be updated with characterized data from silicon measurements at a later date.
2. Long term reliability cannot be assured in conditions above or below Max/Min functional limits.
3. The voltage specification requirements are measured as near as possible to the processor with an oscilloscope set to 100-
MHz bandwidth, 1.5 pF maximum probe capacitance, and 1 M minimum impedance. The maximum length of ground wire
on the probe should be less than 5 mm. Ensure external noise from the system is not coupled into the oscilloscope probe.
Table 7-10. Vcc Sustain (Vcc
ST
) Supply DC Voltage and Current Specifications
Symbol Parameter Segment Min Typ Max Units Notes
1,2
Vcc
ST
Processor Vcc Sustain
supply voltage
All with Intel® 300
Series Chipset Families
PCH
—
1.05
—V 3
8th Gen Intel® Core™ S
Processor with Intel®
200 (including X299)
and Intel® Z370 Series
Chipset Families
1.0
TOB
ST
Vcc
ST
Tolerance All AC+DC:± 5 % 3,4
Icc
MAX_ST
Max Current for Vcc
ST
U-Processor Line
H-Processor Line
S-Processor Lines
——
60
60
80
mA
Notes:
1. Unless otherwise noted, all specifications in this table are based on estimates and simulations or empirical data. These
specifications will be updated with characterized data from silicon measurements at a later date.
2. Long term reliability cannot be assured in conditions above or below Max/Min functional limits.
3. The voltage specification requirements are measured on package pins as near as possible to the processor with an
oscilloscope set to 100-MHz bandwidth, 1.5 pF maximum probe capacitance, and 1 M minimum impedance. The maximum
length of ground wire on the probe should be less than 5 mm. Ensure external noise from the system is not coupled into the
oscilloscope probe.
4. For Voltage less than 1V, TOB will be 50 mV.
Table 7-11. Vcc Sustain Gated (Vcc
STG
) Supply DC Voltage and Current Specifications
Symbol Parameter Segment Min Typ Max Units Notes
1,2
Vcc
STG
Processor Vcc Sustain
supply voltage
All — 1.05 — V 3
TOB
STG
Vcc
STG
Tolerance All AC+DC:± 5 % 3,4
Icc
MAX_STG
Max Current for
Vcc
STG
U-Processor Line
H-Processor Line
——
20
20
mA
Notes:
1. Unless otherwise noted, all specifications in this table are based on estimates and simulations or empirical data. These
specifications will be updated with characterized data from silicon measurements at a later date.
2. Long term reliability cannot be assured in conditions above or below Max/Min functional limits.
3. The voltage specification requirements are measured on package pins as near as possible to the processor with an
oscilloscope set to 100-MHz bandwidth, 1.5 pF maximum probe capacitance, and 1 M minimum impedance. The maximum
length of ground wire on the probe should be less than 5 mm. Ensure external noise from the system is not coupled into the
oscilloscope probe.
4. For Voltage less than 1V, TOB will be 50 mV.
Table 7-9. Processor OPC (Vcc
OPC_1p8
) Supply DC Voltage and Current Specifications
(Sheet 2 of 2)
Symbol Parameter Segment Min Typ Max Unit Note
1,2