Data Sheet
Datasheet, Volume 1 of 2 117
Electrical Specifications
Individual processor VID values may be set during manufacturing so that two devices
at the same processor IA core frequency may have different default VID settings. This
is shown in the VID range values in Section 7.2. The processor provides the ability to
operate while transitionally to an adjacent VID and its associated voltage. This will
represent a DC shift in the loadline.
7.2 DC Specifications
The processor DC specifications in this section are defined at the processor signal pins,
unless noted otherwise.
• The DC specifications for the LPDDR3/DDR4 signals are listed in the Voltage and
Current Specifications section.
• The Voltage and Current Specifications section lists the DC specifications for the
processor and are valid only while meeting specifications for junction temperature,
clock frequency, and input voltages. Read all notes associated with each parameter.
• AC tolerances for all DC rails include dynamic load currents at switching frequencies
up to 1 MHz.
7.2.1 Processor Power Rails DC Specifications
7.2.1.1 Vcc DC Specifications
Table 7-2. Processor IA core (Vcc) Active and Idle Mode DC Voltage and Current
Specifications (Sheet 1 of 3)
Symbol Parameter Segment Min Typ Max Unit Note
1
Operating
Voltage
Voltage Range for
Processor Operating
Modes
U/H Processor Line 0 —
1.52
V
2, 3, 7,16
S-Processor Line -2-Core
0—
S-Processor Line -4-Core
0—
S-Processor Line - 6-Core 0 —
S-Processor Line -(95W)
8-Core
0 — 1.52 + Offset voltage= 1.72V
1, 2, 3,
7,15,16
Icc
MAX
(U-
Processors
)
Maximum Processor
IA Core I
CC
U-Processor Line (28W) -
4-Core GT3+OPC
— — 64 A 4, 6, 7
Icc
MAX
(U-
Processors
)
Maximum Processor
IA Core I
CC
U-Processor Line (28W) -
2-Core GT3+OPC
— — 64 A 4, 6, 7
H-Processor Line (45W) -
6-Core GT2
——
128
H-Processor Line (45W) -
4-Core GT2
——
86