User manual

Intel NUC Board NUC6i5SYB and Intel NUC Board NUC6i3SYB Technical Product Specification
48
2.2.4.2 Add-in Card Connectors
The board supports M.2 2242 and 2280 (key type M) modules.
• Supports M.2 SSD SATA drives
― Maximum bandwidth is approximately 540 MB/s
• Supports M.2 SSD PCIe drives (PCIe x1, x2, and x4)
― Using PCIe x4 M.2 SSD maximum bandwidth is approximately 1600 MB/s
2.2.4.3 Front Panel Header (2.0 mm Pitch)
This section describes the functions of the front panel header. Table 18 lists the signal names of
the front panel header. Figure 13 is a connection diagram for the front panel header.
Table 18. Front Panel Header (2.0 mm Pitch)
Pin
Signal Name
Description
Pin
Signal Name
Description
1 HDD_POWER_LED Pull-up resistor (750 Ω)
to +5V
2 POWER_LED_MAIN [Out] Front panel LED (main
color)
3
HDD_LED#
[Out] Hard disk activity
LED
4
POWER_LED_ALT
[Out] Front panel LED (alt
color)
5 GROUND Ground 6 POWER_SWITCH# [In] Power switch
7
RESET_SWITCH#
[In] Reset switch
8
GROUND
Ground
9 +5V_DC Power 10 Key No pin
Figure 13. Connection Diagram for Front Panel Header (2.0 mm Pitch)
2.2.4.3.1 Hard Drive Activity LED Header
Pins 1 and 3 can be connected to an LED to provide a visual indicator that data is being read from
or written to a hard drive. Proper LED function requires a SATA hard drive or optical drive
connected to an onboard SATA connector.
2.2.4.3.2 Reset Switch Header
Pins 5 and 7 can be connected to a momentary single pole, single throw (SPST) type switch that is
normally open. When the switch is closed, the board resets and runs the POST.