Datasheet

Front Panel Assembly 1U Server Chassis SR1300
Revision 1.2
Intel order number A94544-004
22
Table 14. Video Connector
Pin # I/O Description
1 O Red
2 O Green
3 O Blue
4 O No Connect
5 Pwr GND
6 Pwr GND
7 I Video Switch
8 Pwr GND
9 No Connect
10 Pwr GND
11 No Connect
12 No Connect
13 O Hsync
14 O Vsync
15 No Connect
If a monitor is connected to the front panel video connector, the rear video port (on the server
boards SE7500WV2 and SE7501WV2) will be disabled and the front panel video will be
enabled. The video source is the same for both connectors and is switched between the two,
with the front panel having priority over the rear video. This provides for easy front accessibility
to the server.
In addition, the front panel assembly interface board has two internal connectors:
• A 34-pin header provides control and status information to/from the baseboard through
the HDD backplane board
• A 10-pin USB header provides control for one USB port from the baseboard
A 34-pin flat cable is used to connect the front panel to the selected hard drive backplane. The
backplane provides a signal path to a 100-pin connector, which is then cabled to the server
boards SE7500WV2 and SE7501WV2.
Table 15. Internal USB Header
Pin # I/O Description
1 PWR USB Power 3
2 PWR USB Power 2
3 I/O USB_P2_L
4 I/O USB_P3_L
5 I/O USB_P2
6 I/O USB_P3
7 PWR GND
8 PWR GND
9 NC NC
10 NC NC