Installation Instructions

theinstallerswillnotenterparametersthatexceed
thoseauthorized?
module OTP memory. These parameters cannot be
modified or overridden by sw drivers.
ii) Whatcontrolsexistthattheusercannotoperate
thedeviceoutsideitsauthorizationintheU.S.?
Default mode is always FCC compliant. Other country
modes cannot be activated without receiving three
independent country codes from different APs, otherwise
remains in FCC default mode (always FCC compliant)
d) Isthecountrycodefactoryset?Canitbechanged
intheUI?
Default country code is set in the factory and no UI is
provided for modification.
i) Ifitcanbechanged,whatcontrolsexisttoensure
thatthedevicecanonlyoperatewithinitsauthorization
intheU.S.?
Programmed for default mode which is always FCC
compliant. Always set for default for all start-ups, resets,
timeouts or other host or network events.
e) Whatarethedefaultparameterswhenthedevice
isrestarted?
Always FCC compliant
2. Cantheradiobeconfiguredinbridgeormeshmode?
Ifyes,anattestationmayberequired.Further
informationisavailableinKDBPublication905462D02.
No
3. Foradevicethatcanbeconfiguredasamasterand
client(withactiveorpassivescanning),ifthisisuser
configurable,describewhatcontrolsexist,withintheUI,
toensurecomplianceforeachmode.Ifthedeviceacts
asamasterinsomebandsandclientinothers,howis
this
configuredtoensurecompliance?
This is a client device.
4. Foradevicethatcanbeconfiguredasdifferenttypes
ofaccesspoints,suchaspoint‐to‐pointorpoint‐to‐
multipoint,andusedifferenttypesofantennas,
describewhatcontrolsexisttoensurecompliancewith
applicablelimitsandtheproperantennaisusedfor
eachmodeofoperation.(SeeSect
ion
15.407(a))
This device is not an access point.
Name and surname of applica
nt (or authorized representative):
Date: October 10, 2018 Signature:
Steven C. Hackett
Product Regulations Enginee
Intel Mobile Communicationsr