Installation Instructions

violationofthedevice’sauthorizationifactiv atedinthe
U.S..
2. Describe,ifthedevicepermitsthird‐partysoftwareor
firmwareinstallation,whatmechanismsareprovidedby
themanufacturertopermitintegrationofsuch
functionswhileensuringthattheRFparametersofthe
devicecannotbeoperatedoutsideitsauthorizationfor
operationintheU.S.Inthedescriptionincludewhat
controlsand/oragreementsareinplacewithproviders
ofthird‐partyfu
nctionalitytoensurethedevices’
underlyingRFparametersareunchangedandhowthe
manufacturerverifiesthefunctionality.
RF parameters are programmed into OTP memory at the
factory and cannot be reprogrammed or re-flashed by
third parties.
3. ForCertifiedTransmittermodulardevice s,describe
howthemodulegranteeensuresthathosts
manufacturesfullycomplywiththesesoftwaresecurity
requirementsforU‐NIIdevices.Ifthemoduleis
controlledthroughdriversoftwareloadedinthehost,
describehowthedriversarecontrolledandmanaged
suchthatthemodulartransmitterpa
rametersarenot
modifiedoutsidethegrantofauthorization.
There are no rf parameters that can be modified. All rf
parameters are programmed in OTP memory at the
factory and cannot be modified or overridden by third
parties. The module is not controlled by driver software
on the host and cannot override critical rf parameters
stored in module OTP memory.
SOFTWARECONFIGURATIONDESCRIPTION–KDB594280D02v01r02SectionIII
USERCONFIGURATIONGUIDE
1. Describetheuserconfigurationspermittedthrough
theUI.Ifdifferentlevelsofaccessarepermittedfor
professionalinstallers,systemintegratorsorend‐users,
describethedifferences.
No UI provided.
a) Whatparametersareviewableandconfigurableby
differentparties?
None
b) Whatparametersareaccessibleormodifiableto
theprofessionalinstallerorsystemintegrator?
None
i) Aretheparametersinsomewaylimited,sothat
theinstallerswillnotenterparametersthatexceed
thoseauthorized?
The module micro-code reads the parameters from the
module OTP memory. These parameters cannot be
modified or overridden by sw drivers.
ii) Whatcontrolsexistthattheusercannotoperate
thedeviceoutsideitsauthorizationintheU.S.?
Default mode is always FCC compliant. Other country
modes cannot be activated without receiving three
independent country codes from different APs, otherwise
remains in FCC default mode (always FCC compliant)
c) Whatparametersareaccessibleormodifiableby
theend‐user?
None
i) Aretheparametersinsomewaylimited,sothat
The module micro-code reads the parameters from the