User's Guide

Table Of Contents

Appendix B. Safety and compliance information

This appendix provides safety and compliance statements that are specific to your computer model. The

Generic Safety and Compliance Notices contains safety and compliance statements that are common to all

Lenovo personal computer products. If your computer includes factory-preinstalled wireless modules, the

Regulatory Notice contains compliance information for all the supported wireless modules. To download

these publications, go to

https://www.lenovo.com/compliance.

Laser safety for the ToF sensor

This device is classified as a Class 1 laser product per EN/IEC 60825-1:2014. This device complies with FDA

performance standards for laser products except for conformance with IEC 60825-1 Ed. 3, as described in

Laser Notice No. 56, dated May 8, 2019.

CAUTION:

This device contains a laser that could be damaged during repair or disassembly, which could result

in hazardous exposure to infrared laser emissions. There are no user serviceable parts with the

device. Do not attempt to disassemble or service the device.

Federal Communications Commission (FCC) Supplier’s Declaration of

Conformity

The following information refers to Lenovo product model(s) listed below.

Model name

Machine type (MT)

IdeaPad 5 Pro 14ITL6 82L3

IdeaPad 5 Pro 14ACN6 82L7

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult an authorized dealer or service representative for help.